Mount Downdraft In Cabinet - Bosch HDD80050UC Instructions D'installation

INSTALLATION
3. Check that markings in cabinet line up with ducting coming
from downdraft.
4. Remove downdraft housing from cabinet.
CAUTION
Before cutting hole in cabinet for ductwork, check
for interference with fl oor joists, wall studs, electrical
wiring or plumbing.
5. Cut ductwork hole in cabinet - as well as holes in wall or
fl oor a necessary.

Mount downdraft in cabinet

1. Set downdraft into cabinet/countertop opening as far back
as possible and make sure it is level.
2. Extend support legs and attach to bottom of cabinet with
(2) screws through each leg. Tighten hex screws.
If cabinet bottom is removed: Use blocks as spacers
between fl oor and support legs.
3. Extend upper support brackets and attach to sides of
cabinet with (2) screws through each bracket.
Installations using fl exible blower only:
FLEXIBLE
BLOWER
4. Extend blower support legs and secure them to bottom
of cabinet with a screw through each bracket. Tighten (4)
bolts to secure legs to fl ex blower.
(4)
BOLTS
English 17