Publicité
V1.0
6.
Slide the transmission adapter (#5) onto the end of the ram. Make sure the
receiver is fully seated, then secure with an M10 x 15 Bolt (#9) through the
bolt hole in the receiver.
7.
Install the angle clamps (#3) onto the transmission adapter. Drop an M12 x 25
bolt (#1) through the angle clamp' s slot. And insert the bolt into a corner bolt
hole in the transmission adapter. Secure the bolt with a washer Ø12 (#7) and
an M12 nut (#8). Secure the other angle clamps in the same manner.
8.
Insert each fixed shaft Ø17 x 45 x M10 (#4) through the bolt hole on each
side of the transmission adapter. Make sure the hole in the shaft is vertical
and secure the shaft with an M10 washer (#13) and nut (#14).
9.
Slide an M8 hook bolt (#6) through the shaft opening from the bottom. Secure
with an M8 wing nut (#2). Install the second M8 hook bolt in the same manner.
10. Hook the chain' s (#19) end links onto the hook bolts.
11.
Insert the handle (#21) into the ram receiver.
OPERATION
LOWERING THE TRANSMISSION
Always transport the transmission in the lowered position with the chain
securely fastened.
1.
This jack is limited to the removal, installation and transportation of
transmissions and differentials in the lowered position. Do not alter the
jack or adapters.
2.
Once the vehicle is secured and raised on a hoist, clear the area underneath
the vehicle of tools and people.
3.
Wheel the transmission jack under the transmission. Chock the casters.
4.
Unhook one end of the chain and allow the chain to hang to the floor.
5.
Raise the transmission adapter by turning the handle clockwise to close
the ram' s hydraulic valve. Pump handle until the transmission adapter is at
the desired height.
6.
Stop just below the transmission and level the transmission adapter with
the adjusting knobs. Adjust the position of the angle clamps to
accommodate the size of the transmission. Retighten to secure all clamps
and plates.
Visit www.princessauto.com for more information
High-Lift Hydraulic Transmission Jack
8667909
7
Publicité
