Publicité
Loading The Salt Into The Softener
NOTE:
If your model does not have any water softener, you may skip this section.
Always use salt intended for dishwasher use.
The salt container is located beneath the lower basket and should be filled as
explained in the following:
WARNING
• Only use salt specifically designed for dishwashers use!
Every other type of salt not specifically designed for dishwasher use, especially
table salt, will damage the water softener. In case of damages caused by the
use of unsuitable salt the manufacturer does not give any warranty nor is liable
for any damages caused.
• Only fill with salt before running a cycle.
This will prevent any grains of salt or salty water, which may have been spilled,
remaining on the bottom of the machine for any period of time, which may
cause corrosion.
Please follow the steps below for adding dishwasher salt:
1. Remove the lower basket and unscrew the reservoir cap.
2. Place the end of the funnel (if supplied) into the hole and pour in about 1.5 kg
of dishwasher salt.
3. Fill the salt container to its maximum limit with water, It is normal for a small
amount of water to come out of the salt container.
4. After filling the container, screw back the cap tightly.
5. The salt warning light will turn off after the salt container has been filled with
salt.
6. Immediately after filling the salt into the salt container, a washing program
should be started (We suggest to use a short program). Otherwise the filter
system, pump or other important parts of the machine may be damaged by
salty water. This is out of warranty.
- 15-
Publicité
