Publicité
Before using your dishwasher :
1. Set the water softener
2. Loading the salt Into the softener
3. Loading the basket
4. Fill the
detergent
Please check the section "Water Softener", If you need to set the water softener.
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
the door, switch on the appliance;
Within 60 seconds after the appliance was switched on press the Program button
for more than 5 seconds to enter the water softener setting mode.
Press the
local environment, the setting will change in the following sequence:
H1->H2->H3->H4->H5->H6;
Press the Power button to end the setting mode.
Inside
Outside
dispenser
button again to select the proper set according to your
- 1 -
Publicité
