Publicité
Do not dispose of waste
batteries, waste electrical
and electronic equipment as
unsorted municipal waste.
Waste batteries and waste
electrical and electronic
equipment must be collected
separately. Waste batteries,
waste accumulators, and light
sources have to be removed
from the equipment. Check with
your local authority or retailer for
recycling advice and collection
point. According to local
regulations, retailers may have
an obligation to take back waste
batteries and waste electrical
and electronic equipment free
of charge. Your contribution to
the reuse and recycling of waste
batteries and waste electrical
and electronic equipment helps
to reduce the demand of raw
materials. Waste batteries, in
particular containing lithium, and
waste electrical and electronic
equipment contain valuable
and recyclable materials, which
can adversely impact the
environment and the human
health if not disposed of in an
environmentally compatible
manner. Delete personal data
from waste equipment, if any.
SYMBOLS IN THIS MANUAL
Parts or accessories sold
separately
Note
Warning
INTERFACE BOARD OVERVIEW
The interface board displays the status and
condition of the product.
8
Original Instructions
1
10
9
8
7
6
1.
High load - indicates that the load is too
high for the current setting and the product
might stall. Switch to power mode, increase
cutting height, or reduce walking speed.
2.
Catch/mulch indicator - indicates that
the grass catcher or mulching plug is not
installed. The product does not start without
the grass catcher or mulching plug attached.
3.
Battery charge status button - powers up
the battery level indicator when pressed.
4.
Battery level indicator - indicates the
amount of charge left in the battery packs.
●
If only one LED lights up, the battery
pack capacity is lower than 25%.
●
If two LEDs light up, the battery pack
capacity is between 25% and 50%.
●
If three LEDs light up, the battery pack
capacity is between 50% and 75%.
●
If four LEDs light up, the battery pack is
fully charged. The battery pack capacity
is between 75% and 100%.
5.
Blade check indicator - indicates that the blade
must be checked. Replace the dull blade to
keep the product in good working condition.
After checking or replacing the blade, press
the battery charge status button for more than
5 seconds. The indicator turns off and the
blade check function resets.
6.
Overload indicator - indicates that the
product is overloaded and that the blade
may be jammed.
7.
Mode button - changes the cutting mode
of the product when pressed.
8.
Power mode - indicates that the blade is at
high speed for heavy grass cutting.
9.
Smart mode - indicates that the mower is
able to adjust the blade speed depending on
the load on the product for general cutting.
10. Eco mode - indicates that the blade is at
low speed for thin grass cutting.
2
3
5
4
Publicité
