Publicité
en
calc'nClean
Takes about 43 minutes.
calc'nClean combines the functions
Descale and Clean.
If both programmes are due to be carried
out close together the fully automatic coffee
machine will automatically suggest this
service programme.
The line at the bottom of the display indi-
cates the progress of the descaling process.
F
If there is a water filter in the water
tank 5, be sure to remove it before
starting the service programme.
● Touch A to open the menu.
● Use I to choose Cleaning and care
and touch B to confirm your choice.
● Use I to choose calc'nClean and
touch B to confirm your choice.
● Touch R to begin running the
programme.
The display 3 will indicate the progress of
the programme:
● Empty and re-insert the drip tray 17.
● Open the ground coffee drawer 12.
● Drop one Bosch cleaning tablet in the
drawer 12 and close it.
● Touch R.
The following request appears:
F
Remove water filter if inserted ¢start.
● Remove the filter and then touch
R again.
● Pour lukewarm water into the empty
water tank 5 up to the "0�5 l" mark and
then dissolve one Bosch descaling tablet
TCZ8002 in it. For the TCZ6002 you
should always dissolve two tablets.
● Touch R.
● Place a container with a capacity of 1 litre
under the beverage outlet 4.
46
● Place the end of the suction pipe 4d in
the container.
● Touch R.
The descaling programme will now run for
about 28 minutes.
F
If there is not enough descaling solu-
tion in the water tank 5, you will see
the prompt Refill descaler ¢start.
● Add more descaling solution and then
touch R again.
● Rinse the water tank 5 and refill it with
fresh water up to the "max" mark.
● If you use a filter, replace it now.
● Touch R.
The descaling programme will now run
for about one more minute, and then the
cleaning programme will run for about
7 minutes and rinse the appliance.
● Empty and re-insert the drip tray 17.
Important: Wipe over the appliance
F
with a soft damp cloth to ensure that
you immediately remove any traces
of descaling solution. It is possible for
corrosion to form underneath such
deposits. New sponge cloths may
contain salts that can cause rust films
to form on stainless steel, so such
cloths should always be thoroughly
rinsed before use. Clean the suction
pipe 4d of the drinks outlet particu-
larly carefully.
The appliance has finished descaling and is
ready for use again.
Important: If any of the service
F
programmes is ever interrupted, for
instance by a power failure, please
proceed as follows:
● Rinse the water tank 5 and refill it with
fresh water up to the "max" mark.
● Touch R.
The appliance will be rinsed for approx.
2 minutes for safety reasons.
Publicité
