Troubleshooting; Transportation And Storage - Husqvarna 535LS Manuel D'utilisation

The engine does not start
Check
Stop switch.
Starter pawls.
Fuel tank.
Spark plug.
The engine starts but stops again
Check
Fuel tank.
Air filter.

Transportation and storage

• Store and transport the product and fuel so that
there is no risk that any leakage or fumes comes in
contact with sparks or open flames, for example,
from electrical machinery, electric motors, electrical
relays/switches or boilers.
• When you store and transport fuel always use
approved containers intended for this purpose.
• When you store the product for long periods the fuel
tank must be emptied. Contact your local petrol
station to find out where to dispose excess fuel.
Drain the tank into the appropriate containers and in
a well ventilated area.
18

Troubleshooting

Possible cause
The stop switch is in the stop position.
The starter pawls cannot move freely.
Incorrect fuel type.
The spark plug is dirty or wet.
The spark plug electrode gap is incorrect.
The spark plug is loose.
Possible cause
Incorrect fuel type.
The air filter is clogged.
Transportation and storage
Procedure
Set the stop switch to the start position.
Remove the starter cover and clean around
the starter pawls.
Let an approved service agent help you.
Drain the fuel tank and fill with correct fuel.
Make sure that the spark plug is dry and
clean.
Clean the spark plug. Make sure that the
electrode gap is correct. Make sure that the
spark plug has a supressor.
Refer to technical data for correct electrode
gap.
Tighten the spark plug.
Procedure
Empty the fuel tank and fill it with cor-
rect fuel.
Clean the air filter.
• Ensure that the product is cleaned and that a
complete service is carried out before long-term
storage.
• The transport guard must always be fitted to the
cutting attachment when the product is transported
or in storage.
• Secure the product during transport.
• In order to prevent unintentional start of the engine,
the spark plug cap must always be removed during
long-term storage if the product is not under close
supervision and when you perform all service
measures.
• Allow the product to cool before you put in storage.
1445 - 001 - 22.01.2020