Publicité
en - Warning and Safety instructions
Temporary or permanent operation on an autonomous
power supply system or a power supply system that is not
synchronised with the mains power supply (e.g. island net-
works, back-up systems) is possible. A prerequisite for op-
eration is that the power supply system complies with the
specifications of EN 50160 or an equivalent standard.
The function and operation of the protective measures
provided in the domestic electrical installation and in this
Miele product must also be maintained in isolated opera-
tion or in operation that is not synchronised with the mains
power supply, or these measures must be replaced by
equivalent measures in the installation. As described, for
example, in the current version of BS OHSAS 18001–2
ISO 45001.
Charge the AP10/AP11 battery at an ambient temperat-
ure between 10 °C and 40 °C.
Use the AP10/AP11 battery at an ambient temperature
between 0 °C and 45 °C.
Using the AP10/AP11 battery outside of this ambient tem-
perature range will limit its performance.
Stop using the AP10/AP11 battery immediately if you no-
tice an unusual smell from it, if liquid is leaking from it, if it
is significantly overheating or if it is discoloured or de-
formed. Dispose of the AP10/AP11 battery immediately
(see safety note "Disposing of the AP10/AP11 battery" at
the end of the following section "Correct use", as well as
"Sustainability and environmental protection – Disposing of
old batteries").
42
Publicité
