Publicité
Translation of the Original Operating Instructions
First select the desired operating mode by pressing the respective button once
[( I ) or ( II )] and confirm your choice with the "Start" button (RUN). If you wish to interrupt the device prematurely,
press the "Stop" button (RUN) again.
When the cycle is finished, the cleaner stops automatically. Turn the switch box toggle switch back to OFF before
carefully pulling the robot towards you and to the surface using the cable. Make sure that the underside is facing
the pool wall. Slowly take the pool robot out of the pool and hold the pool robot over the pool to allow the water in-
side to run out.
5.4 Possible change of direction of travel:
There is an adjustable control nozzle on the front and rear of the cleaner for the drive in the water. By adjusting
the two nozzles, the direction of travel can be changed. If the preset travel angle is not satisfactory, stop the
cleaner, carefully remove it from the water and loosen the locking screws. Then manually move the control noz-
zles to the correct position (angular dimension: 1 - 0 - 2) and slightly tighten the locking screws again after ad-
justment (Fig. 5). Now carefully put the cleaner back into the pool and start the cleaning process again.
Fig. 5
The direction of travel changes automatically at fixed time intervals. In the process, both control nozzles alternate
continuously.
Adjustment of the control nozzles:
-
Both sides are at 1:
o
The cleaner moves in an arc to the right - even after changing direction.
-
Both sides are at 2:
o
The cleaner moves in an arc to the left - even after changing direction.
-
The sides are set differently (1 & 0 or 2 & 0):
o
The cleaner always travels straight ahead in one direction (0), and after changing direction to
the right (1) or left (2) (depending on the setting).
-
Both sides are at 0:
o
The cleaner always moves straight forward and back again.
-
The sides are set differently (1 & 2):
o
The cleaner travels in an arc to the left and after changing direction to the right (or the other way
round). Means it travels in a crescent shape.
To ensure good cleaning across all areas, we recommend choosing one of the first three setting options.
5
13
Publicité
