Publicité
1. ATTENTION: Before performing any installation or maintenance tasks, disconnect the elec-
trical device from the power source by pulling the plug out of the socket outlet. Switch off the
main fuse of the main domestic power supply before unplugging the mains cable, if the con-
nection plug or the main power outlet are wet. Never transport or suspend the device by the
mains cable.
2. Ensure that the voltage specified on the type plate of the device agrees with the mains volt-
age.
3. Prior to connecting the device to the mains supply, ensure that the mains cable and the de-
vice are not damaged in any way.
4. The device must have a residual current circuit breaker (RCCB) with a rated residual current
of max. 30 mA connected on the line side. Consult a qualified electrician.
•
Parts of the packaging can be dangerous (e.g. the plastic bags) - therefore keep these out of reach
of children, people who not responsible for their actions and animals.
•
Only use accessories that are included in the scope of delivery, or only those that are specified in
the operating manual. The use of accessories that have not been approved may impair safety.
•
Any use of the device that is not described in this manual may be dangerous and must therefore be
avoided.
•
The device must be correctly assembled with all parts before use. Check that the socket and plug
match.
•
Never touch the mains plug with wet hands.
•
Switch off the device before maintenance, cleaning and after use, and unplug from the mains.
•
Do not leave the device unattended, do not leave it within the reach of children or people who are
not responsible for their actions.
•
Children should be supervised so that they do not play with electrical devices.
•
In case of incidents (e.g. contact with cleaning agents or chemicals) clean the machine with plenty
of clean water.
•
In the event of a malfunction, always pull out the mains plug to avoid any danger.
•
Never leave the device unattended during operation.
•
Carefully check whether the mains connection cable, housing or other parts of the device are dam-
aged; if so, do not use the device under any circumstances and contact the customer service de-
partment for repairs.
•
If you are using extension cables, make sure that they are suitable for the application in question
and that they are placed on a dry surface and protected against water spray.
•
Service and repairs shall only be carried out by qualified personnel. Defective parts of the device
shall only be replaced with original parts.
•
The manufacturer is not responsible for any damage to persons or objects caused by improper use
of the device, or by a failure to follow the instructions provided in this manual.
1.1.
Special safety instructions for the pool robot and switch box
•
The device shall only be operated in water and never without water, because it may otherwise be
damaged. Never use the device without the filter bag.
•
When setting up the switch box, maintain a safety distance of 3 m from the pool.
•
Always fasten your device in a suitable location using the mounting bracket supplied. The switch
box must not be set up loosely on pedestals or similar bases, but only fastened on a level and firm
surface or with the bracket.
•
Always secure the switch box before sliding into the water, the pool robot could possibly pull the
switch box into the pool if it is not secured carefully or if there is insufficient distance to the water.
•
Never use the device if there are people or animals in the water. Avoid working with the device in
the rain.
•
Do not move the device by pulling on the cable.
2. Intended use
This device is intended for private use at home and not for commercial or industrial purposes. Only use
the device to clean and remove dirt in pool systems.
The pool robot is not suitable for cleaning salt water pools. The outside temperature and oper-
ating temperature must not exceed the maximum or fall below the minimum temperatures spec-
ified in the technical data.
10
Translation of the Original Operating Instructions
2
Publicité
