Publicité
11
Insert the wall anchors.
It is recommended that you use the
wall anchors included in the box to
mount your thermostat.
You can use the UWP to mark where
you want to place the wall anchors.
a) Level the wall plate.
b) Mark the location of the wall
anchors using a pencil.
c) Drill anchor holes. If your box
contains red anchors, drill 7/32"
(5.6 mm) holes. If your box
contains yellow anchors, drill
3/16" (4.8 mm) holes.
d) Insert wall anchors.
e) Make sure anchors are flush with
wall.
12
Set R-switch position and insert R-wire or wires.
Set the R-switch up or down based on your wiring notes in Step 7.
Insert wires into the inner holes of the terminals on the UWP. The tabs will
stay down once the wire is inserted.
If you have 1 R-wire (R,Rh, or Rc)
If you have 2 R-wires (R or Rh, and Rc)
1. Set R-switch
to the up
position.
1. Set R-switch
to the down
position.
2. Insert your
or
2. Insert your Rc wire
3. Insert your R
5
RTH7400/RTH7500 Series
R-wire (R, Rh
or Rc) into
R-terminal.
into Rc-terminal.
or Rh wire into
R-Terminal.
Publicité
