Publicité
INSTALLATION STEPS
NOTE: Actual application may vary slightly from illustrations.
Lower the window. Clean the door's painted surface where
the visor will attach.
Slide the front flange behind the mirror cap, use a putty knife
to create a gap if needed. Attach the top and rear flanges to
the door's painted surface.
4 Piece Set
The rear visor attaches with same preparation methods as the front visor.
Attach visor to the vehicle's painted surface.
Page 2 of 7
1
K-520 Primer Adhesion Promoter
General Information
3M K520 is a type of adhesion promiting primer which
provides a superior adhesion( PP) etc...
Remove the tape liner from the rear flange. Peel back 2" of tape
liner from each end of top flange. Lightly apply adhesion promoter
to the tape area which has been exposed from removing the tape
liner and let dry ( approximately 1 minute )
3
Remove tape liner by pulling on free ends. Apply
pressure to top and rear tape flanges to secure.
Raise the window.
www.TrailFX.com
2
4
5
Rev R01;101620
Publicité
