Trailfx 12014X Instructions D'installation

`
Part No.
12014X 12014ZX
22016X 22016ZX
TG58X TG59X
Do not over tighten as screws can be stripped out.
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
DO NOT OVER TORQUE. STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM 45 TO 65 FOOT POUND.
T30 Torx Driver,
1. INSTALLATION PROCEDURE:
WARNING:

Do not transport a pickup truck facing backward with a liner installed.

Air can get under the liner which may result in the liner coming out of the truck and causing damage or injury.
Truck Box Preparation:

Clean truck box of all foreign matter and open any floor drains to ensure ventilation and moisture drainage.
NOTE:

Bed liner can be installed by one person. However, using two people is recommended by the manufacturer.
2. Tailgate Cover Installation Steps
NOTE: Your tailgate cover kit may have more or less hardware than shown.
Page 1 of 9
BEDLINER & TAILGATE COVER
12016X 12016ZX 22014X
22016ZZX 22017X TG04X
TG95X
22014ZX 22014ZZX
TG12X TG45X
Tools Required
Phillips Head Screwdriver
STEP 1 (FIGURE 1):
Using a T30 TORX Driver, remove and save eight (8) screws
from truck tailgate. Remove only the screws indicated by "X".
STEP2
Place plastic Tailgate Cover on metal truck tailgate, lining up
the holes in the plastic Tailgate Cover with holes in metal
truck tailgate.
STEP 3 (FIGURE 3)
Use the eight (8) screws, removed in STEP 1, to fasten the
Tailgate Cover to the tailgate with T30 TORX Driver.
Do not over tighten
DO NOT USE POWER TOOLS.
CUTTING NOT
30-60 min
REQUIRED
support@trailfx.com
1 866 638 4870
Limited Lifetime
www.TrailFX.com
DRILLING
REQUIRED
Rev 062816