Trailfx TG38X Instructions De Montage

`
Part No. TG38X, TG39X
Do not over tighten as screws can be stripped out.
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
DO NOT OVER TORQUE. STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM 45 TO 65 FOOT POUND.
Phillips Screwdriver,
1. INSTALLATION PROCEDURE:
WARNING:

Do not transport a pickup truck facing backward with a liner installed.

Air can get under the liner which may result in the liner coming out of the truck and causing damage or injury.
Truck Box Preparation:

Clean truck box of all foreign matter and open any floor drains to ensure ventilation and moisture drainage.
NOTE:

Bed liner can be installed by one person. However, using two people is recommended by the manufacturer.
2. Tailgate Cover Installation Steps with Screws
NOTE: Your tailgate cover kit may have more or less hardware than shown.
Page 1 of 7
NISSAN BEDLINER/TAILGATE
COVER
Tools Required
Power Screwdriver with Phillips Bit,
STEP 1
Remove the two existing screws from the tailgate latch plate
and discard them.
STEP 2
Center the tailgate cover on truck tailgate. Line up pre-drilled
holes in tailgate cover with hole in truck tailgate (See FIGURE
1).
STEP 3
Using the screws provided in kit (See FIGURE 2), fasten
tailgate cover to truck tailgate using a Phillips screwdriver. DO
NOT OVERTIGHTEN. Plastic nut inserts on truck tailgate will
easily strip out.
STEP 3
Starting at the center hole, use a power screwdriver, center a
self-tapping screw in a pre-drilled hole in tailgate cover and
fasten to truck tailgate (See FIGURE 1).
Do not over tighten as screws can be stripped out.
STEP 4
Repeat Step 3 to remaining hole locations until all are
completed.
CUTTING NOT
30-60 min
REQUIRED
support@trailfx.com
1 866 638 4870
Limited Lifetime
www.TrailFX.com
DRILLING
REQUIRED
Rev 062816