Trailfx 11006X Instructions De Montage

`
Part No. 11006X, 11007X, 21006X, 21007X, 21009X, TG01X, TG13X, TG80X
Do not over tighten as screws can be stripped out.
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
DO NOT OVER TORQUE. STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM 45 TO 65 FOOT POUND.
Phillips Screwdriver,
13 mm Socket or Wrench.
1. INSTALLATION PROCEDURE:
WARNING:

Do not transport a pickup truck facing backward with a liner installed.

Air can get under the liner which may result in the liner coming out of the truck and causing damage or injury.
Truck Box Preparation:

Clean truck box of all foreign matter and open any floor drains to ensure ventilation and moisture drainage.
NOTE:

Bed liner can be installed by one person. However, using two people is recommended by the manufacturer.
2. Tailgate Cover Installation Steps with Screws
NOTE: Your tailgate cover kit may have more or less hardware than shown.
Page 1 of 7
GM BEDLINER/TAILGATE COVER
Tools Required
30-60 min
support@trailfx.com
1 866 638 4870
Limited Lifetime
Power Screwdriver with Phillips Bit,
STEP1
Remove the two screws from tailgate latch plate and set aside
for later use (See FIGURE 1).
STEP2
Center plastic tailgate cover on truck tailgate. Reinsert and
tighten the two latch plate screws that were removed in STEP
1 in the two center holes of tailgate.
STEP 3
Using a power screwdriver, center a self-tapping screw in a
pre-drilled hole in tailgate cover and fasten to truck tailgate.
Do not over tighten as screws can be stripped out.
STEP 4
Repeat Step 3 to remaining hole locations until all are
completed.
www.TrailFX.com
CUTTING NOT DRILLING
REQUIRED
REQUIRED
Rev 062816