Publicité
NO.
Description
1
Screw(ST4*10)
Drill dimension
2
paper
Plastic expansion
3
tube
Expansion
4
screw(ST4*40)
1. Fasten 4pcs hook racks with 8pcs screws(ST4*10) as picture (1).
2. Be sure to keep the distance between the heater and floor, wall and so on at least
30cm as picture (2).
3. Use drill dimension paper to drill top two holes(Φ8) on the wall and put the plastic
expansion tube in the holes then fasten the expansion screws(ST4*40) in the holes
as picture (3).
4. Hang the top two hook racks on the expansion screws (ST4*40) as picture (4).
Mark the two bottom hook racks' position on the wall and take away the heater, then
drill bottom two holes(Φ8) on the wall and put the plastic expansion tube in the
holes as picture (4).
5. Hang the heater on the wall and put the expansion screws (ST4*40) in the bottom
two holes as picture (5).
For Stand
1 – Fit the foot onto the bottom of the body.
2 – Fasten 2pcs foots with 8 screws (ST4*14).
Parts list
Quantity
Note
Used for Wall
8
mounted
Used for Wall
1
mounted
Used for Wall
4
mounted
Used for Wall
4
mounted
3
NO.
Description
Quantity
5
Screw(ST4*14)
6
foot
Instruction
7
Manual
8
Remote
Note
8
Used for Stand
2
Used for Stand
1
/
1
/
Publicité
