Publicité
INNOVATIVE ORBITAL SOLUTIONS
Screens during welding :
Available if « operator dynamic » value is different of zero: to modify paraleters during
welding
Switch to downslope
Operator dynamic :
Welding end:
Join
experience
Time chart to see welding progress
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
English
You can see programmed and measured
values.
-
High pulse information
-
Low pulse information
-
Angle (negative if right rotation)
-
Speed
-
Gaz
To stop immediately the welding (switch to
postgas) and activate the alarm « 0A: ALL
STOP ».
Choose on the left the parameter you want
to modify. Then press + or – buttons to
modify the value.
On the bottom left, you can see the
maximum percentage allowed of the
programmed value.
If the wire speed is displayed and your
machine has left and right buttons, then the
left button act as a push on the button - and
pressing the right button act as a press on
the + button for the wire speed.
Pressing
the
STOP
downslope causes rapid downslope in 2s.
330B Route de Portes Les Valence - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - commerce@axxair.com - www.axxair.com
- 80 -
button
during
Publicité
