Publicité
WARNING
Always operate the grill on a tabletop, no higher than
81.28 cm / 32 in.
Place the propane tank on the ground immediately
adjacent to the tabletop, no further than 61 cm / 24 in from
the grill.
Failure to follow these instructions could cause the
propane tank to overheat and vent propane, which could
ignite, causing serious personal injuries or property
damage and / or a tripping hazard over the gas hose or
propane tank, pulling the grill off the tabletop, causing
serious personal injuries or property damage.
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present.
Compare parts with package contents list and diagram above. If any part is missing or damaged, do not
attempt to assemble, install or operate the product. Contact customer service for replacement parts.
Your Nexgrill Tabletop Grill is pre-assembled. The only assembly required is to connect the foldable
legs and place the flame tamers, cooking grid and control knobs into the grill.
Estimated Assembly Time: 5 minutes.
INSTALLATION INSTRUCTIONS
GAS HOOK-UP
Only the pressure regulator and hose assembly supplied with the grill should be used. Any replacement
pressure regulator and hose assembly must be specified by the grill manufacturer. This grill is configured for
liquid propane. Do not use a natural gas supply.
Total gas consumption (per hour) with all burners set on "HIGH":
Main burners
Total
The installation of this appliance must conform with local codes or, in the absence of local codes, with
either the National Fuel Gas Code, ANSI Z223.1 / NFPA 54, National Gas Propane Installation Code,
CSA B149.1, or Propane Storage and Handling Code, B149.2,or the Standard for Recreation Vehicles,
ANSI A119.2 / NFPA 1192, and CSA Z240 RV Series, Recreation Vehicle Code, as applicable.
LIQUID PROPANE CYLINDER REQUIREMENTS
(9.07 kg / 20-lb Cylinder)
A dented or rusty liquid propane cylinder may be hazardous and should be checked by your supplier. Never
use a cylinder with a damaged valve. The liquid propane cylinder must be constructed and marked in
accordance with the specifications for liquid propane cylinders by the United States Department of
Transportation (DOT) or the National Standard of Canada, CAN / CSA-B339, Cylinders, Spheres and Tubes
for Transportation of Dangerous Goods Commission.
The 9.07 kg / 20-lb cylinder must have a shut-off valve terminating in a valve outlet specified, as applicable,
for connection type QCC1 in the standard for compressed gas cylinder valve outlet and inlet connection ANSI
/ CGA-V-1.
Storage of an outdoor cooking gas appliance indoors is permissible only if the cylinder is disconnected and
removed from the outdoor cooking gas appliance. The cylinder system must be arranged for vapour
withdrawal. The cylinder must include a collar to protect the cylinder valve.
Manifold pressure: (operating) 27.94 cm / 11 in water column (W.C.), (non-operating) 28.45 cm / 11.2 in water
column (W.C.).
The Liquid Propane cylinder must be fitted with an overfill protection device (OPD).
Remove the plastic valve cover from the liquid propane cylinder. Make sure the grill gas hoses do not contact
the grease pan or grill firebox when the liquid propane cylinder is placed into the cart.
20,000 BTU / Hr.
20,000 BTU / Hr.
12
Publicité
