Publicité
Dust Extraction (Fig. 3)
WARNING: DO NOT direct sawdust toward yourself or others. To
avoid injury from flying sawdust, keep the exhaust nozzle either in
the forward position or in the closed position. DO NOT insert
foreign objects into the exhaust opening.
WARNING: ALWAYS connect the track saw to a dust extractor!
WARNING: ALWAYS use a dust extraction device designed in
accordance with the relevant regulations regarding dust emission.
Your tool is fitted with a dust extraction outlet (I).
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs.
accidental start-up can cause injury.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALWAYS wear certified safety
equipment:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
• ANSI S12.6 (S3.19) hearing protection
• NIOSH/OSHA respiratory protection.
Cleaning
WARNING: Periodically blowing dust and chips out of the motor
housing using clean, dry compressed air is a suggested
maintenance procedure. To reduce the risk of serious personal
injury, ALWAYS wear ANSI Z87.1 safety glasses while using
compressed air.
WARNING: When cleaning, use only mild soap and a damp
cloth on plastic parts. Many household cleaners contain chemicals
which could seriously damage plastic. Also, do not use gasoline,
turpentine, lacquer or paint thinner, dry cleaning fluids or similar
products which may seriously damage plastic parts. Never let any
liquid get inside the tool; never immerse any part of the tool into a
liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
Lubrication
This tool has been lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions.
An
No further lubrication is necessary.
Brushes
WARNING: To reduce the risk of injury, DO NOT TIE, TAPE, OR
OTHERWISE LOCK THE ON/OFF SWITCH ON while "running in".
HOLD BY HAND ONLY.
Inspect carbon brushes regularly by unplugging tool, removing the
brush inspection cap and withdrawing the brush assembly. Keep
brushes clean and sliding freely in their guides. Always replace a used
brush in the same orientation in the holder as it was prior to removal.
Carbon brushes have varying symbols stamped into their sides, and if
the brushes are worn down to the line closest to the spring, they must
be replaced. Use only identical D
both brushes. Use of the correct grade of brush is essential for proper
operation of electric brakes. New brush assemblies are available at
your local D
WALT certified service center. The tool should be allowed
E
to "run in" (run at no load without blade) for 10 minutes before use to
19
WALT brushes. Always replace
E
Publicité
