Publicité
MAINTENANCE
IMPORTANT: Unplug the vacuum before performing any maintenance.
CLEANING FILTERS
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Do not use soap. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.
PRE-MOTOR FILTERS
With the dust cup detached, press the Filter
Access buttons on both sides of the back of
the dust cup, then pull out the filter housing.
Pull the foam filter out of the housing, then
lift out the felt filter by the pull tab.
The Pre-Motor Filters should be washed
once a month.
REPLACEMENT FILTERS
Replacement Pre-Motor Filter Kit
XFFKHZ2000
NOTE: The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
s h a r kc l e a n . c o m
POST-MOTOR FILTER
To access the post-motor filter, press the
release latch on the filter cover on the
handheld vacuum. Remove the cover and
lift out the filter.
The Post-Motor Filter should be washed
once every 9 months.
Replacement Post-Motor Filter
XPMFHZ2000
MAINTENANCE
CHECKING FOR BLOCKAGES
CHECK NOZZLE TUBE
Detach the wand, then check the floor nozzle
tube for blockages.
CHECK HANDHELD
Remove the handheld vacuum from the
wand and check all dust cup intake openings
for debris or blockages.
CHECK FLOOR NOZZLE
With the wand detached, turn the nozzle
over to access the bottom cover. With a coin,
turn the three locks counterclockwise and
open the cover. Remove any blockages from
the brushrolls and Debris Intake.
CHECK WAND
Detach the wand and check it for blockages.
s h a r kc l e a n . c o m
Publicité
