Bosch NGM5456UC Manuel D'installation page 9

Install the Cooktop
Insert the cooktop into the cutout. Attach the clamps of
the mounting brackets packaged with the cooktop. Use
the washer and screws provided.
Adjust the mounting brackets to desired position and
tighten screws to cooktop. Insert adjusting screw into
clamp and secure cooktop to countertop.
Attaching Mounting Brackets
Cooktop
A
B/H Hold Down Bracket
C/E Adjusting Screw
Foam Tape (Seal)
D
Wooden Block (to be used with solid surfacing
G
material)
Note: For solid surface material installations:
Insert a wooden block between the end of the screw
▯
and the bottom of the countertop.
Do not overtighten adjusting screw.
▯
Trim excess aluminum tape around cooktop flange.
▯
Tip: Install hold down bracket without the adjusting
screw installed. Turn hold down brackets flush with the
sides of the cutout. This will help with inserting cooktop in
hard-to-reach spaces.
Connect Gas Supply
The gas inlet to the unit is located at the right rear of the
cooktop.
Install the pressure regulator (supplied with unit) to
manifold pipe using Teflon tape on threads of manifold
pipe. Turn to hand tighten plus 1/4 turn, not exceeding 1
turn for alignment. To prevent possible damage to the
gas pressure regulator, install it after the cooktop is in its
permanent position. When the regulator is securely
installed on the manifold pipe, the conversion nut will be
easily accessible.
Pressure Regulator
Manifold Pipe
A
Conversion Nut
B
Pressure Regulator
C
WARNING
9
Do not attempt any adjustment of the pressure
regulator, except when converting to propane.
Adjustments could lead to leaks or cause incorrect
gas pressure to the appliance.
9