Publicité
4.
Overview
Refer to the illustrations on page 2 of this manual.
#
1
2
3
4
5
6
7
8
9
5.
Installation
1.
Install the appliance on a flat, stable and fire-resistant surface.
2.
Make sure that the power switch at the back of the appliance is in the off
position (0).
3.
Plug the power cord into a suitable, earthed mains outlet.
6.
Operation
6.1
Precautions
Make sure both the heater and nozzle are cool before attaching the nozzle.
To use a nozzle, simply slide the nozzle over the air mouth of the air gun. To
remove the nozzle, you can use the U-shaped on the base of the cradle.
At first use, the nozzle may emit some smoke. This is normal and it will disappear
the more you use the nozzle.
Never aim the nozzle at persons or animals. Keep hot air coming from the nozzle
away from the eyes and face.
After use, always leave the nozzle to cool down, switch off and disconnect the
appliance from the mains.
V. 01 – 15/01/2019
Function
heating
cooling
standby
airflow
channel preset
temperature
adjustment
temperature unit
correction value
SET/ENTER buttons
VTSSD6
The element is heating up and the temperature increases.
When the symbol flashes, the temperature is being
maintained at the set value.
The element is cooling down and the temperature is
decreasing. The fan may be whirling.
The element is in standby mode. The nozzle is possible at
or near room temperature.
CAUTION – Metal parts may still be hot!
Use the arrows to set the airflow rate from 0 to 200 cm³/s.
Select CH0, CH1, CH2 or CH3 by pressing the green button
on the hand tool. CH0 is the default operating mode.
Use the arrows to set increase/decrease the temperature.
As set by the user.
Correction value for the heating element.
Setting buttons.
5
Description
©Velleman nv
Publicité
