Publicité
SETTING MOTOR SPEED
GB
According to standard EN 12445, every automation is required to pass the impact tests, which must be carried out using
Perform the impact tests and adjust the speed of movement by means of the trimmer (22 in Fig. 15).
COUPLING TYPE RECEIVER mo e OC o ion
The receivers are "self-learn" type and can memorise several codes on the same channel.
The functions of the two radio channels are:
Channel 1 Step/step
Channel 2 N.C.
To memorise the transmitters proceed as follows:
- Power up the control unit and wait for the receiver LEDs to turn off.
-Transmitter with remote control to be programmed.
The code memory can be reset if required by pressing and holding P1 on the receiver for approx. 15 seconds until
all the LEDs light up.
The aerial must be connected to terminals 18 (sheath) and 19 (control unit), see Fig. 16.
FINAL TESTING
- Check correct operation of the protection devices (anti-crushing system, stop button, photocells, sensitive edges,
etc.)
- Check correct operation of the control devices (S/S pushbutton, remote controls, etc.)
3
Publicité
