Publicité
HOW TO CHANGE THE DECELERATION ZONE DURING CLOSING
GB
The control unit already has a deceleration zone programmed (default value).
This space can be changed during the time programming procedure.
Procedure:
2-After point 10 in "Time programming", press the S/S button again when the desired deceleration zone begins.
3-The control unit stops the gate momentarily to indicate that programming has been completed, and then continues
the closing manoeuvre.
4-Continue programming by following points 11 and 12.
* The memorised values remain stored until a new programming cycle is performed.
ADJUSTING THE RATE OF DECELERATION
The rate of deceleration of the automation can be adjusted using the following procedure:
- press the STOP/PROG button to increase the deceleration rate; after reaching level 4 it returns to 1
NOTE i is im or n o
o ri ion resen in e
FUNCTION SETTING
The various options described can be selected using the function dip-switch (19 in Fig. 15)
- Remember that to memorise a change in settings on the control unit, it is necessary to turn the power supply off
and then back on or momentarily short the two control unit reset pins.
oose
e e er ion r e
om ion.
b e 3
is
ro ri e o e
e's wei
n
e e ree
33
Publicité
