Intermatic GRASSLIN thermio Mode D'emploi page 56

Setting the jumper
1. Undo the screw on the device housing with the Phillips screwdriver.
Fig. 8: Lifting up the jumper
2. Lift up the jumper (Fig. 8/1) in the housing cover using a flat-head screwdriver.
3. Insert the jumper (Fig. 8/1) in the 2-point position (Fig. 8/2).
Closing the housing
4. Place the housing cover on the housing base and tighten the screw on the device housing with the
Phillips screwdriver.
56