Setting The Heating Cycle - Intermatic GRASSLIN thermio Mode D'emploi

Setting the heating cycle

Selecting the heating cycle
Example
If the temperature difference in the room is too large, the heating system is switching ON and OFF too
infrequently; in other words, the number of temperature measurements should be set to a smaller
value. If the heating system switches too frequently, select a higher value for the number of tempera-
ture measurements.
Personal:
52
The number of temperature measurements can be set to 3, 6, 9 or 12 times
an hour (factory setting: 6 times an hour).
In the factory setting, the jumper is inserted in the PID position. In this posi-
tion, you can set the heating cycle. If the jumper is in the 2-point position,
you can set the hysteresis.