Installation In A Flush-Mounted Socket - Intermatic GRASSLIN thermio Mode D'emploi

Installation in a flush-mounted socket

Personal:
• Qualified electrician
Installing the mounting plate
1. Attach the mounting plate to the flush-mounted socket with screws (3.5 x 25 mm) (Fig. 6).
Removing the housing cover
2. Undo the screw on the device housing with the Phillips screwdriver and remove the housing cover.
Connecting
3. Strip the connection wires to a length of 8 mm (cross-section between 1 mm² and 2.5 mm²).
4. Thread the connection wires into the device through the cable feed-through (Fig. 4/7).
46
The arrow (Fig. 6/1) on the mounting plate should point upwards.