Intermatic GRASSLIN thermio Mode D'emploi page 51

6. Insert the connection wires into the corresponding terminal in accordance with the wiring diagram
(Fig. 4) and tighten them.
Installing the housing base
7. Fasten the housing base to the wall-plugs with the screws (3.5 x 25 mm).
Inserting the battery
8. Insert the two alkaline batteries of type 1.5 V AA LR6 into the housing cover, ensuring the correct
polarity (Fig. 5).
Closing the housing
9. Place the housing cover on the housing base and tighten the screw on the device housing with the
Phillips screwdriver.
EN
51