Publicité
Anleitung FSG 518-2 SPK1
Wear safety gloves
Wear goggles
Wear ear-muffs
1. Layout
11. Miter stop
12. Parallel stop
13. Wheel guard
14. Table
15. Water trough
16. Housing
17. Knurled screw for setting the angle
18. Scale for miter cuts
19. Knurled screw
10. Thumb screw
11. Holder for splitter
12. ON/OFF switch
13. Switch housing
15. Diamond cutting wheel
16. Outer flange
17. Side cover
18. Nut
19. Splitter
2. Technical data
Motor rating:
600 W S2 20 min
Motor speed:
AC motor:
230 V ~ 50 Hz
Insulation class:
Protection type:
Protection class
Length of cut:
Length of jolly:
Cutting height 90°:
Cutting height 45°:
Cutting table:
- Dimensions
330 mm x 360 mm
Diamond cutting wheel
ø 180 x ø 25.4
23.05.2006
10:07 Uhr
Seite 7
Noise emission values
The noise produced by this tile cutting machine
is measured in accordance with DIN EN ISO
3744; 11/95, DIN EN ISO 11201: 1996-07 ISO
7960 Annex A; 2/95.
The level of noise at the workplace may exceed
85 dB(A). In this case it is essential to take
suitable precautions to protect the user's hearing
(wear ear muffs!).
Sound pressure level LPA
Sound power level LWA
3. Important notes
Please read this operating manual carefully and
follow the instructions. Use the manual to familiarize
yourself with the machine, its proper use and safety
instructions.
Important!
For safety reasons it is prohibited for children, young
people under the age of 16 years and all persons
who have not read and understood the operating
instructions to use the tile cutting machine.
Portable tile cutting machine for medium tiles
Cutting performed by a diamond cutting wheel.
Jolly cuts with tilting work top up to 45 degrees.
Cutting wheel cooled with water.
Straight fence and mitre fence.
Removable trough as cooling water container.
(To remove, the machine must be lifted slightly.)
3000 rpm
4. Intended use
The tile cutting machine is designed to perform
Class B
cutting jobs on small and medium tiles (floor and wall
IP 54
tiles made of ceramic and similar material) which suit
the machine's size. It is intended in particular for use
I
by DIY enthusiasts and craftsmen. The cutting of
unlimited
wood and metal is prohibited. The machine is to be
used solely for its intended purpose. Any use
unlimited
other than its intended use is a case of mis-use. The
35 mm
user/operator and not the manufacturer shall be
liable for any damage or injury resulting from cases
12 mm
of mis-use. Only those cutting wheels suitable for the
machine are to be used. The use of saw blades is
prohibited. For the machine to be used as intended it
is also imperative to observe the safety instructions,
the assembly instructions and the operating
instructions set out in this manual. All persons
GB
Idle
66.3 dB(A)
79.3 dB(A)
7
Publicité
