Publicité
l
When the delay is set on a programme:
- after pressing "START/RESET", the
countdown time "00:00" appears on the
display with flashing " : "
- if you press any button (except for the
"ON/OFF", "Progr. per 3 sec" buttons),
the programme name is displayed for a
single scroll on the display and then the
delay time is displayed again.
- When the time has elapsed, the programme
name is displayed for a single scroll on
the display and the remaining time will
be displayed as "0:00h".
l
To start the countdown, press the
Start/Reset button. The display will show
the time remaining to the end of the
programme. At the end of the countdown,
the programme will start automatically.
If the delayed start is not confirmed by
pressing the "Start/Reset" button,
after approx. 10 sec. the delayed start
will be cancelled.
(Only for free-standing models)
The length of the selected cycle will
be shown on the display. At the end of
the countdown, the programme will
automatically start and the length of
the selected cycle will be shown on
the display.
Proceed as follows to cancel a delayed
start:
l
Hold the "Start/Reset" button down for at
least 3 seconds. "00" will appear on the
display "RESET" and audible signals will
sound.
l
The delayed start and the selected
programme
will
dashes will appear on the display.
l
At this point, to set off the dishwasher, a
new programme and any option buttons
must be selected, as indicated in the
"PROGRAMME SETTINGS" paragraph.
be
cancelled.
Two
Activation/Muted END-OF-
PROGRAMME signal.
You can deactivate turning on and off of the
audio signal as follows (the default setting is
active):
The dishwasher must ALWAYS be off
before you start this procedure.
l
Open the door.
l
Turn on the dishwasher by holding the
"ON/OFF" button down for about 3 secs.
l
Hold down the "Progr." and "ON/OFF"
buttons for about 5 secs.
l
The message "SETTINGS" will appear
on the display and the indicator lights of
the "SMART DOOR/EXPRESS" and
"TABS" buttons will be on.
l
Pressing the "Progr." button until the
"BUZZER" parameter is selected.
l
Parameter adjustment is performed by
pressing the "SMART DOOR/EXPRESS"
(-) and "TABS" (+) buttons to change the
value from YES to NO and vice versa.
l
Switch off the dishwasher by pressing the
"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
MEMO FUNCTION (Memorising
the last programme used)
The dishwasher must ALWAYS be off
before you start this procedure.
l
Open the door.
l
Turn on the dishwasher by holding the
"ON/OFF" button down for about 3 secs.
l
Hold down the "Progr." and "ON/OFF"
buttons for about 5 secs.
100
Publicité
