Publicité
Sheep shearing machine GT494(K) / GT694(K) and cutter head GT369
3. Technical specifications
Rated current
Hub rotation rate
(maximum)
Safety rating
Safety
200 W
2 650 1/min
II,
Equivalent to EN 60335-1,
IEC 60335-2-8
CE marking according to directives
89/336/EEC and 73/23/EEC
Marking of electric and electronic
devices according to directive
2012/19/EU (WEEE), see Disposal.
4. Operation
DANGER
Risk of death by electric shock!
Do not open the product.
Connect the product only to a grounded power
supply.
DANGER
Risque de mort par choc électrique!
Ne pas ouvrir le produit.
Branchez le produit uniquement à une
alimentation électrique mise à la terre.
AVERTISSEMENT
Avant d'accéder aux bornes de raccordement,
tous les circuits d'alimentation doivent être
déconnectés.
The appliance shall never be left unattended when plugged in.
Never operate this appliance when it has a damaged cord or plug,
when it is not working properly, after it has been dropped or
damaged, or after it has been dropped into water.
Do not reach for an appliance that has fallen into water. Unplug
immediately from receptacle.
Return the appliance to a service center for examination and repair.
Keep the cord away from heated surfaces.
Do not use while bathing or in a shower
Do not place or store appliance where it is able to fall or be pulled
into a tub or sink. Do not place in or drop into water or other liquid.
Except always unplug this appliance from the electrical outlet
immediately after using.
Keep the air openings free of lint, hair, and similar objects.
Never drop or insert any object into any opening.
Do not use outdoors or operate while aerosol (spray) products are
being used.
Do not use this appliance with a damaged or broken comb, as it has
the potential to result in facial injury.
Attach the plug to the machine first, then to outlet
Before plugging in and switching on the machine, check to ensure
that the voltage on the rating plate is in accordance with the
voltage at your site (see type plate).
The machine can be switched on and off with one hand by means
of the sliding switch 51, which is located midway between the two
ends of the machine (see fig.).
To disconnect the machine, slide the slide switch 51 to the off
position and then remove plug from outlet.
15
Publicité
