Publicité
COMPACT-EX[GD]
2.5 WARNING LABEL
Do not open when energized or in presence of explosive atmospheres.
For the Enclosure:
WARNING – Potential electrostatic charging hazard – clean with a damp cloth or antistatic products.
When calotte CZ4000-M.., is present:
WARNING – Potential electrostatic charging hazard – clean with a damp cloth or antistatic products.
WARNING: Tcable xx°C, (See the marking label).
2.6 CERTIFICATES
Atex Certificate
IMQ 22 ATEX 006 X
IECEx Certificate
IECEx IMQ 22.0001 X
2.7 ENCLOSURES DEGREE OF PROTECTION
IP66
The equipment is marked with the lowest degree of protection dependant by certified components mounted on the equipment.
(See the marking label on the product).
2.8 AMBIENT TEMPERATURE RANGE TAMB.
The equipment is certified for a maximum ambient temperature range -50°C to +60°C with appropriate components/accessories.
The ambient temperature range will be limited by the component (actuator, switch, pilot light, instruments etc.)
with the worst characteristics.
The ambient temperature is marked on the label and the control station should not be used outside this range.
3. INSTALLATION
Installation shall be carried out by suitably trained personnel in accordance with the applicable code of
practice (e.g. IEC / EN 60079-14) and the provisions of the national safety and accident prevention regulations
and this instruction manual.
3.1 SAFETY INSTRUCTIONS
The IP rating of the enclosure shall be maintained by the use of correct arrangement of cable-gland and blanking plug elements
in accordance with their safety instructions and the installation rules.
The enclosures have to be installed vertically.
3.2 ACCESSORIES
The installation of the accessories must be performed before the installation of the enclosure, and following the relevant instruction
sheets.
• Back-plates made of zinc plated steel.
• Earth continuity plate type L (internal) made of zinc plated steel for metallic cable glands.(optional).
• Earth-stud (stud, nuts and plain washer) made of brass.(optional).
• Cable-glands and blanking-plugs.
• Threaded nipple with brass nut (used for assembling COMPACT-EX[GD] size 1 and size3 ).
• Blanking plug for covers elements.
Only approved and genuine SCAME accessories must be used.
MP00075
17
ZP91193-1
Publicité
