Publicité
If in doubt consult a qualified electrician
There are no user serviceable parts inside this product
G
except those referred to in the manual. Always refer
B
servicing to qualified service personnel. Never remove
any part of the casing unless qualified to do so; this unit
contains dangerous voltages.
Warning!
For your protection if this product is to be used outdoors
it should not be exposed to rain or used in damp
locations. Do not place the product on damp surfaces,
use a workbench if available. For added protection use
a suitable residual current device (R.C.D.) at the socket
outlet.
Note: If the mains cable requires replacing it must be
replaced with an identical one and fitted by a
qualified person.
5.4 On/Off switch (ref. 8)
5.4.1 D 200/8/24 - D 200/10/24 (Fig. 2a)
DN 200/10/xx - DN 230/10/xx (Fig. 2c)
D 230/10/50 V (Fig. 2d) - D 270/10/100V (Fig. 2e)
To switch on the equipment set the On/Off switch (ref.
8) to position I.
Move the On/Off switch (ref. 8) to position O to switch
off the equipment.
5.4.2 D 200/8/6 - D 115/8/6 SIL (Fig. 2b)
To switch on the compressor, pull out the red knob (ref.
8) to position I.
To switch off the compressor, press the red knob (ref. 8)
in again to position O.
5.5 Adjusting the pressure
● You can adjust the pressure on the pressure gauge
(ref. 6) using the pressure regulator (ref. 7).
● The set pressure can be taken from the quicklock
coupling (ref. 5).
5.6 Setting the pressure switch
The pressure switch is set at the factory.
FUNCTION
Cleaning of intake filter and/or
substitution of filtering element
Draining tank condensate
5.6.1 D 200/8/6 - D 115/8/6 SIL - D 200/8/24
5.6.2 D 200/10/24 - DN 200/10/xx - DN 230/10/xx -
6. CLEANING AND MAINTENANCE
Pull the power plug before doing any cleaning and
maintenance work on the appliance.
Wait until the compressor has completely cooled
down. Risk of burns!
Always depressurize the tank before carrying out
any cleaning and maintenance work.
6.1 Cleaning
● Keep the safety devices free of dirt and dust as far
as possible. Wipe the equipment with a clean cloth or
blow it with compressed air at low pressure.
● We recommend that you clean the appliance
immediately after you use it.
● Clean the appliance regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plastic
parts in the appliance. Ensure that no water can get
into the interior of the appliance.
● You must disconnect the hose and any spraying tools
from the compressor before cleaning. Do not clean
the compressor with water, solvents or the like.
6.2 Condensation water
The condensation water must be drained off each day
by opening the drain valve (ref. 11) (on the bottom of the
pressure vessel).
MAINTENANCE RESUMPTIVE TABLE
AFTER THE FIRST
100 HOURS
●
Periodically and at the end of work
20
Switch-on pressure 6 bar
Switch-off pressure 8 bar
D 230/10/50 V - D 270/10/100V
Switch-on pressure 8 bar
Switch-off pressure 10 bar
Warning!
Warning!
Warning!
EVERY 100 HOURS
●
Publicité
