Publicité
Translation of the original instructions
Connection / disconnection :
• Disconnect the power supply before plugging or unplugging the
connections to/from the battery.
• Always ensure the Red clamp is connected to the «+» battery
terminal first. If it is necessary to connect the black clamp to the
vehicle chassis, make sure it is a safe distance from the battery and
the fuel line. The charger must be connected to the mains.
• After charging, disconnect the charger from the mains, then
disconnect the negative clamp from the car body and then
disconnect the positive clamp from the battery, in this order.
Connection :
• The charger must be connected to an earthed power supply.
• The connection to the power supply must be carried out in compliance
with national standards.
Maintenance :
• If the power supply cable is damaged, the replacement cable must
be obtained from the manufacturer or its service team.
• Maintenance should only be carried out by a qualified person.
• Warning ! Always disconnect from the mains before performing
maintenance on the device.
• The device does not require any specific maintenance.
• If the internal fuse is melted, it must be replaced by the manufacturer
(GYS dedicated sales service) or by an equally qualified person to
prevent any accidents.
• Do not use solvents or any agressive cleaning products.
Regulations :
• The Machine is compliant with European directives.
• The declaration of conformity is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).
• Equipment in compliance with British requirements. The British Dec-
laration of Conformity is available on our website (see home page).
• Equipment in conformity with Moroccan standards.
• The declaration C( مCMIM) of conformity is available on our
website (see cover page).
Waste management:
• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a household bin.
GYSFLASH 50.24
EN
13
Publicité
