Publicité
-
Where supply disconnection is required do it always in such a way that an operator
located near the machine can check that the plug remains removed.
-
Three Phase models connected to the fixed wiring : to disconnect the device use the
disconnection means of the electrical installation (refer below) and lock it in the opened
position.
-
Do not change the plug in any way.
-
Close supervision is required when this product is used near children.
-
This appliance shall not be used by children. Keep the appliance and its cord out of
reach of children
-
Children shall not play with the appliance
-
Appliances may only be used by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and if it is ensured they fully
understand the hazards involved.
-
Before and after each use of the mincer : to ensure appropriate hygiene dismantle and
wash as described in this instruction all the parts coming into contact with the food
-
Use only original branded discharge plates having holes of diameter from 3 mm to 8
mm. Plate's holes diameter should never exceed 8 mm or be oval shaped. Plate
thickness should never be less than 5 mm
-
Do not use jets of water for cleaning
-
All models are equipped with a thermal cut-out that protects the motor in stopping it
in case of continuous overload. Should this occur disconnect the machine, identify and
remove the cause of this overload and wait for the machine to cool down before
starting it again. Should it be not possible to identify and remove the overload cause
contact imperatively Seller's after sales service before any restarting attempt.
-
Caution for all models: in order to avoid a hazard due to inadvertent resetting of this
integrated thermal cut-out, the appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly switched on
and off by the utility.
Three Phase models: electrical connection to the fixed wiring shall mandatorily be
-
done by a duly qualified technician. A suitable all-pole means for disconnection that
can be locked in the opened position and a correctly rated overload protective device in
accordance with the local wiring rules must be incorporated in the fixed wiring.
PRESENTATION
-
The aim of this handbook is to provide the costumer with as much information as possible about the item and with the instructions for its
use and maintenance in order to keep it working efficiently and to preserve performances.
-
This handbook should be given to people in charge for the use and periodical maintenance of the item
-
The handbook should be kept in good conditions and stored in an easily accessible place for rapid reference.
-
Reber is in a continues development of its products to improve technical, safety, ecological and commercial features; products could be
different from this data sheet due to this non stop evolution.
-
V. 01.2020
Reber srl–Via Valbrina 11– 42045 Luzzara (RE) Italia–www.rebersrl.it–E.mail: info@rebersrl.it
Service / Spare Parts: www.rebersrl.it
The characteristics – photos – drawings are indicative and the manufacturer can modify them without any notice
RESPONSABILITY OF THE SUPPLIER
The supplier will be not responsible for any damage to people or material other than the described machines.
The supplier does not guarantee the conformity of the machine to the rules in force in the extra EU countries where the machines could be installed
and particularly regarding accident prevention.
Internal
Publicité
