Walking Treadmill
The belt
is slipping.
(1)
The belt tension is too loose.
►
Increase the belt tension in
the manner described in the
"Maintenance" chapter – "Adjusting
the Belt Tension".
The belt
drifts to the side.
(1)
The belt has slipped.
►
Centre the belt in the manner
described in the "Maintenance"
chapter – "Aligning the Belt".
The belt (1) is making unusual noises.
The lubrication has dried out.
►
Lubricate the belt in the manner
described in the "Maintenance"
chapter – "Lubricating the Belt".
There are loose screw connections.
►
Check the fit of all connections.
Tighten loose screws or similar
fittings.
Error message "E5"
The device is overloaded.
►
It is not suitable for users who weigh
more than 100 kg.
Rotating device parts are blocked.
►
Remove the blockage.
The lubrication has dried out.
►
Lubricate the belt (1) in the manner
described in the "Maintenance"
chapter – "Lubricating the Belt".
The belt (1) is worn out.
►
The belt needs to be replaced by an
expert.
There are faults with the motor or
electronics.
►
Contact the customer service
department.
Error message "E1", "E2", "E3",
"E4", "E6", "E7"
There is a fault with the motor or
electronics.
►
Contact the customer service
department.
DISPOSAL
Dispose of the packaging material
in an environmentally friendly man-
ner so that it can be recycled.
The battery should be removed
before disposing of the remote
control and disposed of separately
at suitable collection points.
The device is governed by the
European Directive 2012/19/EU
on waste electrical and electron-
ic equipment (WEEE). Do not
dispose of it as normal domestic
waste, but rather in an environ-
mentally friendly manner via an
officially approved waste disposal
company.
EN
23