Publicité
use may lead to damage to the appliance or personal injury.
GB
• Operating the appliance for any other purpose shall be
deemed as a misuse of the device. The user shall be solely
liable for improper use of the device.
Grounding installation
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connec-
tions must be properly installed and grounded.
Main parts of the product
(Fig.1 on page 3)
1. Cover cap
2. Jug lid
3. Jug
4. Blade assembly
5. Motor base
6. Control panel
Remark: The content of this manual applies for all listed
items unless specified otherwise. The appearance may vary
from the shown illustrations.
Control panel
(Fig.2 on page 4)
7. Power switch (ON/ STANDBY): Press to switch ON the ma-
chine; Press again to switch to STANDBY mode
8. Speed control: Select and then press to the desired speed.
8a. Low
8b. Medium
8c. High
9. Timer: Select and then press to the desired time (30s /
45s / 90s)
10. Pulse button: Full speed impulse movement. Press and
hold to operate, release the button to stop.
11. Digital control display
Spare parts or accessories
(Fig.3 on page 4)
12. Pusher
Circuit diagram
(Fig.4 on page 4)
A. EMC board
B. Micro switch
C. Main PCB
Exploded diagram with part list
(Fig.5 on page 5)
Part no.
1
2
3
4
10
Part name
Quantity
Cap cover
Jug lid
Jug
Blade set
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all
accessories. In case of incomplete or damaged delivery,
please contact the supplier immediately. In this case, do not
use the device.
• Clean the accessories and the appliance before use (See
==> Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resist-
ant surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may
emit a light odor during the first few uses. This is normal and
does not indicate any defect or hazard. Make sure the appli-
ance is well ventilated.
Operating instructions
• NOTE! For safety reason, the machine can only start to op-
erate with the jug installed properly on the motor base.
• Check if the machine is at the STANDBY mode.
• Unplug the machine, take out the jug from the motor base.
1
• Pour all the ingredients into the jug and close it with the jug
lid and place the cover cap correctly in place.
1
• Place the whole jug onto the motor base.
1
• Connect the power plug to a suitable electrical power supply
socket.
1
• Press the power switch once to enter STANDBY mode.
Seal ring of blade assembly
Fixed plate
Screw for clutch
Clutch
Jug pad
mounting screw
Top housing
micro switch assembly
Motor assembly
Bottom housing
Power supply cord
Wind deflector bowl
Pusher
Control panel
Display PCB
Protection film
EMC PCB
Screw for main PCB
Main PCB
Rubber feet
1
1
1
1
1
4
1
1
1
1
1
1
1
1
1
1
1
4
1
4
Publicité
