Note: For better positioning first fill the bases of
the snake (3) and gorilla (6) with water and then
inflate them.
4. Connecting the garden hose
To connect a garden hose use a suitable hose
coupling and attach it to the product's water
connection (fig. D).
Filling the product with water
Fill the product slowly and do not leave it unat-
tended while filling.
Always fill the product up to the marking shown.
Important! Do not exceed the filling
capacity of 300l without water sprayer
attached!
Emptying the product
Open the drainage hole and allow the water to
run out (fig. E).
Note: Please follow the local regula-
tions regarding specific requirements
for disposing of water from swimming
pools.
Disassembly
Allow the product to dry completely before
folding it up. Remove the garden hose. Take off
all individual removable parts.
Deflate the product as follows:
1. To deflate the main chamber rapidly, open the
seal (fig. F).
2. To deflate the other components pull out the
valve and squeeze the valve stem lightly so
that the air can escape or insert the deflation
tube into the seal to allow the air to escape
rapidly.
Repairs
Minor leaks or holes can be repaired with the
repair patch supplied.
Important!
Do not inflate the product for 20 minutes after
repair! Do not use the patch for leaks or holes
on the seam.
1. Let the air out of the product completely.
2. Clean the area around the leak thoroughly.
The area must be dry and free from grease.
6
GB/IE/NI
3. Cut out a piece of the repair material that is
big enough for its edges to overlap the dama-
ged area by about 1.3cm.
4. Peel the patch off the paper, place it on the
damaged area and press tight.
Storage, cleaning
Exchange the water in the product frequently, es-
pecially in hot weather and if it is soiled. When
not in use, always store the product clean, dry
and uninflated at room temperature. The valves
should always be closed during storage. Clean
the product only with water or soapy water,
never with abrasive detergents. When storing for
the winter do not put any sharp objects on the
product and do not apply talcum powder.
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the pack-
aging materials out of the reach of children.
Dispose of the products and the
packaging in an environmentally friendly
manner.
The recycling code is used to identify
various materials for recycling. The code
consists of the recycling symbol – which
is meant to reflect the recycling cycle – and a
number which identifies the material.
Notes on the guarantee and
service handling
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
With regard to complaints, please contact the
following service hotline or contact us by e-mail.
Our service employees will advise as to the
subsequent procedure as quickly as possible.