Publicité
INSTALLATION AND POWER
SUPPLY
CAUTION:
● Be careful not to pinch your fingers when
opening and closing the battery cover.
● Return the battery compartment locker to the
original position, after installing or removing
battery cartridge. If not, battery cartridge may
accidentally fall out of the speaker, causing injury
to you or someone around you.
● Always close and lock the battery compartment
locker before moving the speaker.
● Always switch off the speaker before installing or
removing the battery cartridge.
● Be careful not to drop or strike the speaker.
Broken shell may slash your finger or stab
your body. Damaged speaker may exhibit
unpredictable behavior resulting in fire, explosion
or risk of injury.
● Hold the speaker and the battery cartridge firmly
when installing or removing battery cartridge.
Failure to hold the speaker and the battery
cartridge firmly may cause them to slip off your
hands and result in damage to the speaker and
battery cartridge and a personal injury.
IMPORTANT:
● Reduced power, distortion, "stuttering sound" or a low
battery icon appearing on the display are all signs
that the main battery pack needs to be replaced.
● The battery cartridge can't be charged via the
supplied AC power adaptor.
● The battery cartridge is not included as standard
accessories.
Installing or removing slide battery
cartridge (Fig. 2-4)
● To install the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way until
it locks in place with a little click.
● If you can see the red indicator on the upper side of
the button, it is not locked completely. Install it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the speaker, causing injury to
you or someone around you.
● Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, sliding it from the
speaker while pressing the button on the front of the
cartridge.
Indicating the remaining battery
capacity (Fig. 5-6)
Only for battery cartridges with the indicator
1. Indicator lamps
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
● XGT/LXT battery cartridge
Indicator or lamps
Lighted
Off
NOTE:
● Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from
the actual capacity.
● The first (far left) indicator lamp will brink when the
battery protection system works.
● When the battery power is low, please replace the
battery.
Using supplied AC power adaptor
Remove the rubber protector and insert the adaptor
plug into the DC socket on the right hand side of the
speaker. Plug the adaptor into a standard mains socket
outlet. Whenever the adaptor is used, the battery pack
is automatically disconnected.
CAUTION:
● Always disconnect the AC power adaptor
completely before moving the speaker. If the AC
adaptor is not removed, it may cause an electric
shock.
● Never pull and/or drag the cord of the adaptor.
If not, the speaker may accidentally fall down,
causing injury to you or someone around you.
IMPORTANT:
● In order to disconnect the speaker, the mains adaptor
should be removed from the mains outlet completely.
8 ENGLISH
2. Check button
Remaining capacity
Blinking
75% ~ 100%
50% ~ 75%
25% ~ 50%
0% ~ 25%
Charge the battery
The battery may
have malfunctioned
Publicité
