Publicité
Right-hand, left-hand cutting conversion
To switch the cutting blade from one side to the other proceed as follows:
1. Disassemble the water hose fasteners and then reassemble on the opposite side in each case.
2. Loosen screws (24), remove cutting disc guard (1) and protective hood (22).
3. Loosen screws (25) and then reassemble covering plates (26) on the opposite sides.
4. Reassemble cutting disc guard (1) and protective hood (22) on the required sides.
Note:
Carry out the following additional conversions if needed:
- Loosen screws (27), turn guide wheel around and then reassemble screws (27).
- Loosen screws (28), turn around dirt catcher and then reassemble screws (28).
T00835GB.fm
16
OPERATION
Publicité
