Publicité
OPERATION
Water tank
The floor saw has been equipped with an integrated, removable water tank (15). The filler opening (16) can be
found at top left side. The water supply can be adjusted (17) and also turned off.
To remove the water tank proceed as follows:
1. Empty the water tank completely if required. For this purpose open the metering tap (17) completely.
2. Release the hose coupling (18) once the tank has been completely drained.
3. Turn hand crank (5) to a horizontal position.
4. Apply the parking brake (6).
5. Pull the tank out by the recessed grip (20).
The adjustable hose coupling (19) can be used as a feeder point (1/2-inch) for an external hose connection.
Parking brake
To apply the parking brake (6) push bolt (21) towards the right until it locks in the spokes of the back wheel.
Always place the machine on a flat, level and non-skid surface. The maximum grade should not
o
exceed 10
.
14
T00835GB.fm
Publicité
