Publicité
13. Place the filler material into the burner pan by hand. To avoid clogging the burner with dust
do not dump the bag into the burner pan. Position the filler across the burner pan to a level
that is 1 inch (2.54 cm) above the burner tube. Make sure you do not block the igniter housing
with the filler material to ensure proper ignition and operation.
If using glass filler, Real Flame suggests first placing a layer of lava rock in the burner pan
to improve airflow.
Lid
Filler Material Warning
• Do not overfill the burner area with rock or glass filler; use only the specified amount. The
depth of the filler should not be more than 1 inch (2.54 cm) above the burner tube. Only
Real Flame filler products have been certified and tested for safe use with this Real Flame
fireplace. Using other filler material may result in increased popping and cracking or increased
carbon monoxide emissions.
• Do not light or use this fireplace if the filler is wet. Ensure filler is completely dry before lighting.
Intense heat can cause wet filler to explode and hit someone causing property damage,
serious injury, or death.
• Keep away from the fireplace for at least 20 minutes during initial start-up as filler could
retain moisture from manufacturing and shipping.
WARNING
!
If the table is installed with a portion of the hose under
the table, the hose must be secured, so that no part of
the hose will be within 1" or come in contact with the
underside of the burn pan or where the hose will not be
accidentally damaged or pinched.
Failure to secure the hose in a safe location may result in
a gas leak that could cause property damage, injury,
or death. Follow all other hose inspection instructions
listed in this manual.
ASSEMBLY INSTRUCTIONS
1"
Coil the hose next to the
door for easy inspection.
13
Igniter
Housing
Valve
The hose should not come within 1"
from the bottom of the burn pan.
Do not coil the hose
beneath the valve.
Publicité
