Installation and start-up
1
5×
2×
2
3
All manuals and user guides at all-guides.com
Unpacking the parasol
Supplied with:
- parasol
- Crank with stud
- binding
- protective cover
- 5 fastening screws (floor fastening)
- 5 support screws
- 2 round-headed screws (standpipe fastening)
- 2 washers
- 3 allen key
- Standpipe cover
- Operating instructions
!
Dispose of packaging material properly
and keep away from children.
Do not make use of defective material.
In the event of any damage, inform the
transport service provider immediately.
Placing the parasol down
!
Carefully place the parasol on a
clean, horizontal surface. The parasol
is very heavy. Work in a threesome
and hold the parasol securely.
Prepare the floor fastening
Place the floor fastening in accordance
with the separate instructions.
minimum
maximum
Size
weight
wind speed*
[cm]
[kg]
[km/h (Bft.)]
300 x 300
120
55 (7)
400 x 300
150
45 (6)
* maximum wind speed when it is securely anchored
in the ground.
26
27
4.2
f a c i
b a c k
5.1
5.2
5.5
6.1
4
Pre-assemble standpipe
4.1
1. Pull standpipe out of the mast
2. Place parasol on standpipe The side
with the two thread holes must face
backwards (away from the parasol)
4.4
4.5
3. Adjust holes / position
4. Place 5 washers in position
5. Pre-assemble standpipe with 5
hexagonal screws
!
The side with the two thread holes
n g
5x
must face backwards (away from
w a r d
the parasol).
s
5
5.3
Pre-assemble parasol
1. Place parasol on standpipe
2. Attach parasol tightly to standpipe,
using 2 washers and 2 round headed
screws
3. Put crank in place and screw tightly
4. Remove strap
5. Open parasol with the crank
6. Make sure that the inner parts are
engaging
!
The parasol is very heavy. Work in
5.6
a threesome and hold the parasol
securely.
6
6.2
Fixing the parasol in place
5x
1. Make final adjustments of parasol
position
2. Fix parasol in place by tightening the
5 hexagonal screws
6.3
6.4
3. Push standpipe cover on both sides,
click into place
4. Push standpipe cover down as far as
it will go
5. Close parasol