Publicité
EN
STEPS FOR CLEANING THE ICE-MAKING PARTS
Fig. 1
To clean:
1.
Be sure your icemaker is connected to a water supply.
2.
Open the door of the unit and use both thumbs to open the transparent
window and slide it upwards (Fig. 1).
3.
Clean the inner parts that make contact with water.
4.
Add appropriate amounts of acetic acid solution to the indicated position
shown (Fig. 2)
5.
Reinstall the transparent window to prevent water leakage. (Fig. 3)
6.
Press the (Timer) Clean button on the operation panel for more than 5
seconds to start the cleaning program, which will run for 15 minutes.
7.
You can pull the drain plug (Fig. 4), to drain the
cleaned water solution.
8.
After the solution is drained, reinstall the drain
plug.
9.
Start another cleaning cycle again, then when it
finishes, press the (ON/OFF) button to start ice
production
10. Ice produced in the first 15 minutes is not
recommended for consumption.
11. Dry the interior and exterior with a clean, soft cloth.
www.newair.com
Fig. 2
Fig. 3
Fig. 4
24
Publicité
