Publicité
INSTALLING THE STAINLESS STEEL DOOR HANDLE
To install the door handle, follow the instructions below:
1.
Locate the two set screws and fix it into the pilot holes shown in (1).
2.
Find the door handle (2) and align the holes to the set screws.
3.
Use the included hex wrench to fix the handle screws (3) to the set screws.
INSTALLATION LOCATION REQUIREMENTS
•
This unit is not for outdoor use. Maintain the proper room and inlet water
temperatures according to above specification tables to ensure proper ice
making performance.
•
This unit should not be located near any significant source of heat.
•
The unit should be located on a firm and level foundation at normal
countertop height.
•
There must be at least 2-inch clearance at the rear of the unit for
connection to the power supply and 10 inches clearance in front to allow
for the door to open and to maintain adequate air circulation.
www.newair.com
EN
13
Publicité
