Publicité
EN
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose sets supplied with the appliance to
connect to water mains. Old hose sets should not be reused.
1. Connect the water supply hose to the unit
First, remove the tape on the water inlet port (indicated in the following
illustration as "B") located at the back of the unit, then use your finger to press
and remove the plastic circular cover ("A"). Next, insert one end of the white
water hose into the water inlet port and push inward completely. Follow step
#2 in the diagram. Water hose connection is now complete.
2. Connect the water drainpipe
Remove the black water drainage cap (indicated as "A" in above illustration),
then connect the gray drainage pipe. Connect the other end of the drainpipe to
the main water drainage pipe in your house. Note: the white washer included
in the packaging fits between the water inlet port and the white-water tube.
3. Connect the water hose to the faucet of the main water supply system
First, install the supplied water quick-connector to the water faucet by screw
thread. Second, remove the clipper from the water quick-connector, insert the
other end of the water hose into this quick-connector port completely, then re-
install the clipper. The water hose is now connected to the water supply. Note:
The water faucet is supplied by the unit owner and is not included in the unit
assembly.
Important: The water pressure of the main water supply system must be at
least 0.04-0.6 MPa.
www.newair.com
S T E P 1 :
R e m o v e t h e
t a p e f i r s t
W a t e r i n l e t p o r t o n
t h e u n i t b a c k
R e m o v e t h e
c l i p p e r f i r s t
S T E P 2 : I n s e r t t h e
w a t e r h o s e
T h e n i n s t a l l
b a c k t h e c l i p p e r
W h i t e w a t e r
h o s e ( a c c e s s o r y )
F i r s t i n s e r t t h e
w a t e r h o s e i n w a r d
c o m p l e t e l y
16
Publicité
