Publicité
Spacing for recessed area or closet
*Recommended/Minimum spacing
NOTE: No other fuel-burning appliance can be installed in the
same closet as a dryer.
All dimensions show recommended and minimum spacing
allowed.
Additional spacing should be considered for ease of
installation and servicing.
Additional clearances might be required for wall, door, and
floor moldings.
Additional spacing of 1" (25 mm) on all sides of the dryer is
recommended to reduce noise transfer.
For closet installation with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.
Companion appliance spacing should also be considered.
Custom under-counter installation:
27"
(686 mm)
1"
(25 mm)
39"
minimum
(990 mm)
1"
(25 mm)
Closet Installation (stacked washer and dryer):
/
5
"
1
2
(140 mm)
1"
(25 mm)
Minimum installation clearances (dryer only):
Front
Recessed
NA
Closet
1" (25 mm)
Minimum
Under
NA
Counter
0" (0 mm) rear spacing is allowed for straight-back venting only.
For steam models only, inlet hose must not be kinked.
Mobile Home – Additional installation
requirements
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part 3280 (formerly the
Federal Standard for Mobile Home Construction and Safety, Title
24, HUD Part 280) or the Standard for Mobile Homes, CAN/CSA-
Z240 MH.
Mobile home installations require:
Metal exhaust system hardware, which is available for
purchase from your dealer.
Mobile Home Installation Hold-Down Kit.
Special provisions must be made in mobile homes to introduce
outside air into the dryer. The opening (such as a nearby
window) should be at least twice as large as the dryer exhaust
opening.
6"
(152 mm)
3"
(76 mm)
48 in
(310 cm
24 in
(155 cm
3"
(76 mm)
1"
(25 mm)
Sides
Rear
0" (0 mm)
0" (0 mm)
0" (0 mm)
0" (0 mm)
1" (25 mm)
0" (0 mm)
2
)
2
2
)
2
Top
18" (457
mm) to
cabinet/
shelf
18" (457
mm) to
cabinet/
shelf
0" (0 mm)
9
Publicité
