Trailfx TG09X Instructions De Montage

`
Part No.
TG09X TG10X
TG99X
Do not over tighten as screws can be stripped out.
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
DO NOT OVER TORQUE. STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM 45 TO 65 FOOT POUND.
Phillips Screwdriver
Drill with 3/8" Drill Bit
1. INSTALLATION PROCEDURE:
WARNING:

Do not transport a pickup truck facing backward with a liner installed.

Air can get under the liner which may result in the liner coming out of the truck and causing damage or injury.
Truck Box Preparation:

Clean truck box of all foreign matter and open any floor drains to ensure ventilation and moisture drainage.
NOTE:

Bed liner can be installed by one person. However, using two people is recommended by the manufacturer.
2. Tailgate Cover Installation Steps
Page 1 of 10
FORD FLARESIDE & OTHER
BEDLINER & TAILGATE
TG11X TG25X TG26X TG29X TG52X
Tools Required
T30 Torx Head Driver
NOTE: Your tailgate cover kit may have more or less
hardware than shown.
STEP 1
Remove 8 (eight) existing factory installed tailgate screws
(Designated by "X" in FIGURE 1). Set aside for later use.
STEP 2
Center tailgate cover on truck tailgate. Line up predrilled holes
in tailgate cover (See FIGURE 2) with the 8 holes in truck
tailgate.
STEP 3
Place washers, supplied in kit, on the screws that were
removed in Step 1 (See FIGURE 3) and fasten tailgate cover
to the truck tailgate using appropriate driver.
CUTTING NOT
30-60 min
REQUIRED
support@trailfx.com
1 866 638 4870
Limited Lifetimes
www.TrailFX.com
DRILLING
REQUIRED
Rev 062816