Publicité
3. WIRING INSTALLATION
Electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards. This
range hood must be properly grounded. Turn off electrical power at service entrance before wiring.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an
escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed and grounded.
Set the electrical power supply within the space covered by the decorative flue.
Improper grounding can result in a risk of electric shock. Consult a qualified electrician if the grounding instructions
are not completely understood, or if doubt exists as to whether the appliance is properly grounded. Do not use an
extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near the appliance.
Position the outlet offset so that the power cord will not interfere with the round duct.
Place the outlet at a maximum distance of 33
hood (see illustration at right). Make sure this does not interfere with a mounting brac-
ket fastening area or with the decorative flue (where the flue touches the wall).
4. INSTALL HOOD MOUNTING BRACKET
• When cutting or drilling into wall, do not damage electrical wiring and other hidden utilities.
• When building framework, always follow all applicable construction codes and standards.
Construct wood wall framing that is even with the surface of wall studs.
Wood wall framing must be at least 1/2" thick and 3" high. Fasten wood wall
framing to wall studs for a solid installation.
Make sure that the height of the framing will allow the mounting bracket to be
secured to the framing within the dimensions shown.
After wall surface is finished, carefully center and level the hood
mounting bracket over installation location. Secure it to wall framing using
3 no. 8 x 1½" screws.
Using a level, draw a vertical line up to the ceiling starting from the mounting
bracket center.
WARNING
!
WARNING
!
7
/
" from where the cord exits from the
16
WARNING
!
4
HE0159
W
F
RAMING BEHIND DRYWALL
HD1034A
5
39
/
" =
8
BOTTOM OF HOOD
5
43
/
" =
8
BOTTOM OF HOOD
33
7
∕
16
MAX
ALL STUDS
26"
ABOVE COOKTOP
30"
ABOVE COOKTOP
"
.
Publicité
