Maintenance Activities - Holmatro CU 4007 Mode D'emploi

8.3 Maintenance schedule
This schedule is an average. Depending on the intensity of use of your equipment, Holmatro can
provide a specific maintenance schedule for you.
/i
Object
General
Hydraulic couplers
Dust caps
Hydraulic hoses
Blades
Snap ring of hinge pin
Hinge pins
Centre bolt
Deadman's button
1. Holmatro dealer maintenance.
8.4

Maintenance activities

8.4.1 General
• After every use, check the blades for damage, and if necessary, grind off / file away any burrs that
are visible on the cutting edge.
• Check the operation of the equipment.
8.4.2 Hydraulic couplers
• Check the couplers for damage. Have a Holmatro Certified Technician replace damaged couplers.
• Clean the coupler with luke warm water and a mild soap solution.
• Dry the couplers.
• Lubricate the end of the coupler with hydraulic oil or inject WD-40.
• Lubricate the locking ring by injecting WD-40 into the space between the back section and the
locking ring.
• Connect the couplers and check whether the coupler locks automatically. Check the locking by
pulling the hoses apart with a normal manual effort. The couplers must not slip.
• Disconnect the couplers by turning the locking ring and pulling it backwards.
• Connect and disconnect the couplers a few times to improve the internal lubrication of the locking
system.
CU4007
Action
Check
Check, clean, lubricate
Check, clean, lubricate
Check
Check
Check
Lubricate
Lubricate
Check
916.000.967_005
Time interval
x
x
x
x
x
x
x x
x x
x
EN
x
x
x
x
x
x
x
x
x
35